We used one of the cups that came with the.

Oct 10, One of the more confusing project is how to remove bushings on the GM A-Body and G-Body platforms is the rear axle housing bushing.

Being able to identify where you are willing to put your effort will not only help you select the right project car but also keep you moving forward on the project.

We use a set of weber county tree cutting permit thread, washers, and nuts to make a DIY bushing removal tool, this also works for replacing bushings as well. Companies do offer an all-in-one bushing tool if you’re interested in just purchasing check them out below!

Jan 14, DIY Dana 30 Control Arm Bushing Replacement to a Jeep's death wobble are the upper control arm bushings that are pressed into the Dana 30 axle under your Jeep. 30 Control Arm Bushing Removal. Sep 09, You will need to remove the threads in the 2" side of the pipe fitting to clear the flange side of the bushing.

About minutes with a die grinder does the trick. Don't forget to use some kind of spacer when removing the bushings from the UCAs - you don't want them to bushmulch.barted Reading Time: 5 mins. Jul 18, place jacks to support axle beam.

From the factory the rubber is joined to the outer and inner sleeve.

raise axle diy axle bushing remover slightly to remove strain from bolt. Remove bolts (2) - use a hammer and punch - should come right out. Lower beam slowly- coil springs will pop out- catch them so they dont damage break lines or abs sensors. remove lower shock mount from beam and lower with jacks.